Foppapedretti iWood Manual De Instrucciones página 17

• ENGLISH •
ASSEMBLY
USING THE TRAVEL SYSTEM ACCESSORIES
WARNING: This vehicle has been designed for children of above 6 month age!
If you wish to use one of the accessories with which you can equip with your chassis car seat
iWood of the Group 0+ or carry cot iWood developed for when your baby is small, pls. Operate it
by following these instruction.
Remove the seat from the chassis (see the paragraph "INSTALL THE SEAT").
(fig.39, fig.40)
USING THE INFANT CAR SEAT AND CARRYCOT TRAVEL SYSTEM ACCESSORIES
IMPORTANT: the travel system accessories must be secured to the chassis only in the parent facing
position.8
CARRY COT (fig.41, fig.42)
Montage: Align the carry cot with the adaptors at both side, and press until "click" sound.
Remove: Lift up the buttons of the adaptors with one finger at each side and lift up the seat to
remove the carry cot.
(fig.43, fig.44)
ADJUST CANOPY
Montage (fig.43)
Press the buttons at both side to adjust he handlebar of carry cot (fig.44).
Open the zip or the viewing window, according to the model purchased, for ventilate.
ADJUST THE BACKREST (fig.45)
Lift up the adjusting Holder to adjust the backrest up, press the button situated on the upper part
of the Holder and push the Holder down to adjust the backrest down.
Hook the support bar to the frame to prevent swinging movement of the carrycot when using it on
uneven terrains.( fig.46)
FITTING THE MOSQUITO NET (fig.47)
Fit the mosquito net over the handlebar of carry cot, as shown.
Fasten the mosquito net using the press fastener, as shown.
Ventilation (fig.48)
Open the zip, according to the model purchased, to ventilate the inside of the carrycot.
CAR SEAT (fig.49, fig.50)
Montage: Align the carry cot with the adaptors at both side, and press until "click" sound.
Remove: Lift up the buttons of the adaptors with one finger at each side and lift up the seat to
remove the car seat.
17