Intended Use; Personnel Qualification - WIKA TF35 Manual De Instrucciones

2. Safety

2.1 Intended use

The Model TF35 screw-in thermometer with plug connection is designed for
temperature measurement.
GB
The screw-in thermometer has been designed and built solely for the intended
use described here, and may only be used accordingly.
The technical specifications contained in these operating instructions must be
observed. Should the instrument be improperly handled or operated outside
of its technical specifications, it has to be taken out of service immediately and
inspected by an authorised WIKA service engineer.
The manufacturer shall not be liable for claims of any type based on operation
contrary to the intended use.

2.2 Personnel qualification

Skilled personnel
Skilled personnel are understood to be personnel who, based on their techni-
cal training, knowledge of measurement and control technology and on their
experience and knowledge of country-specific regulations, current standards
and directives, are capable of carrying out the work described and indepen-
dently recognising potential hazards.
Special operating conditions require further appropriate knowledge, e.g. of
aggressive media.
6 WIKA Operating Instructions Screw-in Thermometers, Model TF35
WARNING!
Risk of injury should qualification be insufficient!
Improper handling can result in considerable injury and damage
to equipment.
The activities described in these operating instructions
„
may only be carried out by skilled personnel who have the
qualifications described below.
Keep unqualified personnel away from hazardous areas.
„