Heating Up Before Every Use - Silvercrest SEM 1100 B3 Instrucciones De Uso

3) Place the sieve holder
which is located next to the hot water shower
turning it clockwise until the handle of the sieve holder
4) Place a cup under the sieve holder
5) Close the steam control
symbol).
6) Switch the appliance on with the on/off switch
7) The red control lamp
perature indicator
8) As soon as the green heating-up control lamp
so" button
NOTE
► You may need to empty the cup in between. Interrupt the process by pressing
the "Espresso" button
9) After about 1 minute, stop the pump by pressing the "Espresso" button
again.
10) Wait until the green heating-up control lamp
The warming-up is concluded. You can now prepare espresso.

Heating up before every use

Before you can prepare an espresso or cappuccino, the appliance must be
heated up.
1) Switch the appliance on using the on/off switch
lights up. Neither the "Espresso"
be pressed in. Ensure that the steam control
as possible.
2) Place the sieve holder
which is located next to the hot water shower
turning it clockwise until the handle of the sieve holder
3) Press the "Espresso" button
the water tank
holder, press the "Espresso" button
4) Wait until the green heating-up control lamp
5) Press the "Espresso" button
through for 20 seconds before stopping the pump again.
The preheating process is completed. You can now make an espresso/cappuccino.
■ 36 │ GB │ IE
in the appliance by inserting the "INSERT" mark,
(turn it as far as it will go in the direction of the " - "
lights up. After a short time, the pointer in the tem-
will begin to rise.
. Allow the water to flow for about 1 minute.
. Empty the cup and press the "Espresso" button
again so that water flows through the appliance.
in the appliance by inserting the "INSERT" mark,
. As soon as water starts exiting the openings in the sieve
, into the appliance and then
.
.
lights up, press the "Espres-
lights up again.
. The red control lamp
nor the "Steam"
is turned towards " - " as far
, into the appliance and then
so that the appliance draws water from
again to stop the pump.
lights up.
again and allow hot water to flow
is facing the front.
buttons should
is facing the front.
SEM 1100 B3