Front Wheels; Rear Wheels - KIKKA BOO BEETLE Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNINGS
If the stroller is not used in accordance with these instructions, it may cause serious injuries.
• Avoid serious injuries caused by falling or sliding.
• Always use the seat belt.
• Never leave the child unattended.
• Do not lift the stroller when the baby is in it, the baby may slip and fall.
• Be very careful when using the stroller on steep slopes, stairs, escalators, beaches, mud or poor roads.
• Do not let your child stood in or on the stroller.
• The stroller is designed to transport one child.
• Always activate the brakes when the stroller stops.
• To avoid the risk of su ocate, keep all plastic and other packing materials away from children.
• This stroller supports a maximum of 20 kg, please do not exceed this weight to avoid damage to the product and serious accidents.
• Make sure that all locking mechanisms are in the locked position before placing the baby in it and using it.
I. LIST OF PARTS
1. Handles; 2. Canopy; 3. Adjustable seatback; 4. Basket; 5. Wheels; 6. Footrest; 7. Lock button on the front wheels; 8. Adjustable footrest
pad; 9. Five-points seat belt; 10. Safety board;
II. FOLDING THE STROLLER
1. Pull out the shutter regulator to fold it.
2. Pull out the safety lock.
3. Fold the trolley as shown in the picture.
4. Fully lock the lock with the lock hook to prevent it from being opened.
III. UNFOLDING THE STROLLER
With one hand grab the handle and press the seat with the other. Then pull up strongly on both sides. Step on the docking lock until the
stroller is fully opened and the coupling parts are locked.
IV. ASSEMBLY OF THE WHEELS
FRONT WHEELS: Raise the front wheel as shown. Align central the holes of the two front wheels with the tubes on the base structure.
The sound "click" means that it is matches. Press the disassembly button on the top of the front wheel and then remove the front
wheels.
REAR WHEELS: Install the rear wheels to the tubes in the stroller construction by tightening the spring.
To release: press the spring and release the rear wheel.
V. SEATBACK ADJUSTMENT
To adjust the backrest with one hand, pull the plastic latch and adjust the length of the belt with the other. he seatback may be
adjusted in 5 di erent positions.
ATTENTION: PLEASE ADLUST THE BACKREST CAREFULLY WHEN THE BABY IS IN THE STROLLER TO AVOID INJURY.
VI. ACTIVATION OF COURSE THE FRONT WHEELS AND ACTIVATION OF THE BRAKES
To activate the forward course of the front wheels, please press on the targeting mechanism shown on the picture. Push the brake arm
when you stop the stroller even for a while to avoid moving the stroller. Try pushing the stroller to check if the mechanisms are locked.
VII. INSTALL THE SAFETY BOARD AND FOOTREST PAD ADJUSTMENT
To remove the safety board, press the buttons on both sides of the board at same time. To adjust the footrest pad, push the buttons at
same time into the vent on the side of the pad and adjust the desired position.
VIII. RESTRAINT SYSTEM
Place the pins in the center buckle until you hear the click. You should always be sure that the baby is properly fastened. If not, you need
to adjust the belts.
IX. CLEANING AND CARE
Clean the canopy with a brush. Wipe dry with a dry cloth and let it dry n the shade. Make sure all detergents are removed. To remove
stains use a mild detergent to apply directly and then rinse with water.
ENGLISH

Publicidad

Tabla de contenido
loading

Tabla de contenido