Product Familiarisation - Triton TWX7 TOWH Instrucciones De Uso Y Seguridad

Specification
Product Code:
Dimensions (L x W x H):
Weight:
As part of our ongoing product development, specifications of
Triton products may alter without notice.
General Safety
• Check the condition of the equipment before use.
• If any part of the lifting equipment is found to be damaged or
worn, it must be repaired with genuine replacement parts at an
authorised service centre before the equipment is used.
• Do not modify any lifting equipment. Any attempt to tamper with
this equipment will invalidate its guarantee and could result in
serious injury to yourself or others around you.
• The load must be free to lift. If the load is caught, or restricted
during lifting, overloading of the lifting equipment will result in
potential injury and damage to equipment.
• Protective footwear should be worn by the operator, and any
person near to the danger area.
• Lifting equipment must only be operated by persons who are
clearly familiar with the operating instructions.
• Do not change from lifting to lowering rapidly. Allow the load to
come to a complete stop before changing direction.
• Do not lift an object to a greater height than is absolutely
necessary.
• If you are in any way unsure about the safe method of using this
equipment, do not use.

Product Familiarisation

1. TWX7TOWH - TWX7 Rugged Tow Handle
2. T-type Fixing Bolt
3. M6 x 10mm Nut
Intended Use
Rugged tow handle for use with TWX7 Triton Workcentre to assist
with transportation of the Workcentre.
Unpacking Your Tool
GB
• Carefully unpack and inspect your product. Fully familiarise
yourself with all its features and functions
• Ensure all parts of the product are present and in good condition.
If any parts are missing or damaged, have such parts replaced
before attempting to use this product
4
Original Instructions
TWX7TOWH
470 x 150 x 226mm
3kg
Before Use
See Fig. I
1. Remove the knob and washer from the Workcentre by rotating
the knob anticlockwise
2. Slide the Tow Handle (1) onto the screw and refit the knob and
washer, but do not fully tighten to allow movement while fitting
the other side of the Handle
See Fig. II
1. Insert the four T-type Fixing Bolts (2), with the screw thread
facing outward, into the slots on the rail on the underside of the
Workcentre (2 x Bolts in each slot)
2. Locate the threads through the holes on the Tow Handle (1)
3. Secure the Handle using the M6 x 10mm Nuts (3) and a 10mm
spanner (not supplied)
4. Tighten the knob on the other end of the Handle and check all
fixings are tight and secure before use
Disposal
• Tools may contain traces of tool oil, other lubricants and
pollutants. Therefore, tools should not be disposed of with
household waste
• Contact your local waste disposal authority for information on the
correct way to dispose of this tool