caprari MEC-A Serie Instrucciones De Servicio página 15

Example of a pump code : MEC-MG100/2C
Speciality = no indication
S = various specialities
Discharge port diameter
Hight Torque
Number of stages
Impeller reduction / combination
Example of pump code:
Multistage centrifugal pump with horizontal shaft
U = with metal internal parts
T = with mechanical seal
TA = with high pressure seal
Speciality = no indication
S = various specialities
Discharge port diameter
Type of construction
Number of stages
Example of pump code: BHR200
Multistage centrifugal pump with horizontal shaft
Speciality = no indication
S = various specialities
Discharge port diameter
Become thoroughly familiar with the instructions in the documents consigned with the product. This will enable you to work in complete safety and to
obtain the best performance the product is able to offer.
The following instructions apply to the standard version of the product operating in normal conditions. Special versions, shown by the product code,
may not fully comply with the instructions herein (when necessary, the manual will be supplied with additional information).
manufacturer being obliged to give prior notice.
the manufacturer shall not be held responsible for any deriving damages to persons, animals or property.
ATTENTION: - the pump is supplied without oil. Pour lubricant into the bearing housing before starting (the procedure is described in paragraph
also damage the hydraulic parts in versions with thermoplastic resin internals.
Caprari S.p.A.
MEC-A / MEC-MR / MEC-AG / MEC-MG / HM / HMU / BHR
MEC-MG
HM
BHR
... HT /2
100
... -2
40
...
200
C
GB