Disassembly/Assembly Of The Sb750 Tm - Invacare ScanBed 750 Manual Del Usuario

Operating the built-in mattress support extension
Warning! In order to avoid entrapment / suffocation, it is essential to avoid
extending the bed ends without extentioning the mattress support accordingly.
See page 14: Mounting the limitation crossbar under the leg section
The mattress support extension is mounted using the Allen key.
The Allen key is kept on the inside of the cross bar at the head end.
1. Remove the wooden side rails (cf. chapter 5).
2. Remove the 2 screws for fastening the fitting below the side
bar
by means of the Allen key.
3. Pull out the fitting so that it extends 16 cm, insert the 2 screws
again and retighten them.
4. Loosen the 2 screws below the mattress handle on the leg sec-
tion,
pull the handle completely up, and retighten the screws.
5. Insert the mattress support extension.
6. Disassembly/assembly of the SB750
Disassembly
1. Make sure that the castors have the brakes on.
2. Dismount all accessories.
3. Run the bed to the marked height level so that the cams on the base frame's
guide way and the shear arms are opposite each other.
4. Disconnect the power supply.
5. Remove the locking cam from the control unit.
6. Disconnect the plugs of backrest, thigh and leg motors and check that the cables
are not caught in the base frame.
7. Remove the 2x2 finger screws in the side bars.
8. Pull the head top frame out of the inserts in the side bars to
stop and lower the section onto the floor.
9. Release the 2 lock fittings/snap locks on the foot top frame by
pulling out the locking pin and turning it to the right.
10. Lower the foot-section of the top frame and lift it off the base
frame. Remove the head
section of the top frame
from the base
frame.
11. Connect the base frame to
the mains again and lower
it completely.
9.
15
3.
TM
7.
8.
10.