Setup; Receiving The Bed; Main Parts Of Bed; Assembly Of Mattress Support - Invacare Sonata Manual Del Usuario

3 Setup

3.1 Receiving the bed

When you receive the bed, check the packaging. If the bed shows any
signs of damage upon delivery, please read Section Warranty.
WARNING!
Risk of personal damage
There is a risk of entrapment or squeezing, while
assembling or disassembling of the bed.
– The assembly of the bed and mounting of accessories
must be done by authorized or trained personnel.
– Follow instructions carefully.
IMPORTANT!
– To avoid condensation the bed should not be used
until it has reached a temperature of 10-40° C.
IMPORTANT!
– After each assembly, check that all fittings are properly
tightened and that all parts have the correct function.
WARNING!
– The standard electrical equipment must not be
combined with electrical equipment that is not
designed for this bed.

3.2 Main parts of bed

The bed can be configured either for manual or electrical
operation.
A
Scope of delivery:
A Mattress support, head section
B Mattress support, foot section
D Pair of side rails
E Motor / control box or crank for head section
F Motor or crank for thigh section
G
Pair of bed ends
H
Lifting pole (optional)
Hand control
1574228-D
2 pcs. of mattress support retainers (2–section beds)
4 pcs. of mattress support retainers (4–section beds)

3.3 Assembly of mattress support

CAUTION!
Risk of injuries or finger pinch
– Keep your fingers away from movable parts during
assembling, disassembling or adjusting.
IMPORTANT!
Before any use and before operating the bed:
– Check that the bed is correctly mounted according
to instructions.
– Check that all screws are properly tightened.
– Ensure that the pipe pins are fully inserted through
both holes of the fixation and that the spring clip is
completely locked.
After assembly of the mattress support; check:
– that all plugs of the motors and hand control are
correctly connected to the control unit according to
the printed symbols.
– that top frame, head- and leg end are completely
pushed together.
– that the lock pin is engaged.
– that bed ends are correctly attached.
Sonata can have either a complete or a separated mattress support.
If your bed is equipped with a complete mattress support, proceed to
3.5 Mounting of bed ends and legs, page 8 .
Assemble the separated mattress support
1.
Turn the mattress support up-side-down on a flat, clean surface.
2.
Place the two inserts in the head end of the mattress support and
push the ends together.
3.
Tighten with the two thumb screws.

3.4 Electrically operated mattress support

The longer motor (assembled on the control box) operates the
backrest.
Setup
7