Starmix Airstar T-C1 Instrucciones Para El Manejo página 19

Installing the mounting plate
See Fig. C, D.
CAUTION
Unsuitable installation material!
Risk of injury caused by the device falling down.
Before installation:
1. Check if the screws and dowels supplied with the device are suitable for the surface material.
1. Select a wall with a sturdy, weight-bearing surface.
2. Observe the installation height and minimum distances.
3. Have suitable fastening material to hand for installation on the wall.
4. Use the mounting plate as a template on the wall to mark the drill holes.
5. Drill the holes.
6. Fasten the mounting plate on the wall.
Installing the device
See Fig. E, F, G.
DANGER
Live electrical supply line and device components!
Risk of deadly electric shock in case of contact.
Before performing any work on the device:
1. Unplug the power cord. With direct connection: Switch off the circuit breaker or unscrew the
fuse.
2. Secure against accidental switching on.
Observe the following conditions for the electrical connection:
– Only connect the device to a properly installed grounded socket.
– With fixed connection: The supply line must have a switch-off device, e.g. a circuit breaker that can be
switched off or a screw-in fuse.
– Connect the device to an electrical supply line with a residual current circuit breaker.
– Do not connect other loads to the electrical supply line of the device.
CAUTION
The device can become detached from the mounting plate!
Risk of injury caused by the device falling down.
The locking screw for the air intake grille also serves to fasten the device to the mounting plate.
If the locking screw is not properly tightened:
1. Ensure that the device cannot be accidentally pushed off of the mounting plate.
1. Unscrew the locking screw on the air intake grille on the underside of the device.
2. Pull the air intake grille downwards out of the device.
3. Remove the electric terminal cover.
4. Connect the electrical supply line to the terminal, see Fig. F.
5. Put the electric terminal cover back on.
6. Attach the electric terminal cover with the screw.
7. Insert the device from the top in the 4 lugs on the mounting plate.
8. Push the device down up to the stop.
9. Put one hand on the top of the device to hold it and insert the air intake grille into the device from the
bottom.
en
19