Inserting hammer
drill bit or chisel
Inserting tools
Tool removal
Switching
between
hammer drilling,
chiselling
ENGLISH
Always disconnect the plug from the socket before carrying out any work on the
machine.
The following tools can be inserted in the drill-hammer chuck using the SDS-max
shank:
– Hammer-drill for concrete and brickwork
– Pointed chisel, flat chisel, hollow chisel, tile chisel
– Adapter for geared drill chuck or
Only use accessories with SDS-max shank!
1.
Clean and grease the shank of the bit.
2.
Push bit into chuck turning it lightly, the
chuck locks the bit in to the chuck
automatically.
3.
Check that the bit is properly locked into
place. It must be possible to move it back
and forth.
4.
Pull back plastic ring in direction of arrow
and remove bit.
Depending on the inserted tool the machine
can be operated with additional rotation
(SDS–max–drills) or without additional
rotation (SDS–max–chisels). For additional
rotation turn the dial accordingly.
hammer drilling
In "adjusting position" the chisel can be turned by hand to the required angle.
Afterwards lock the spindle with the selector lever while turning the chisel slightly.
To help the lever lock into position twist the inserted bit slightly when switching
gears.
Do not switch when the machine is under load.
During no-load operation the pneumatic hammer mechanism is not yet activated
even if the hammer mechanism is switched on. A safety device suppress the snap
die from idle stroking on the tool used (hammer drill/chisel). To activate the
pneumatic hammer mechanism all you have to do is to firmly push the running
machine against the working material. This unlocks the snap die from the safety
device, and drilling with light pressure is now possible.
3
rotary stop (chiselling)
adjusting position
1
2
spindle locking position
PNEUMATIC 6000 S