Overview And Use - HQ-Power MICW48 Manual Del Usuario

Features
4.
• dual 8 channel UHF microphone system
• with infrared ACT (Automatic Channel Targeting) function for easy synchronisation between
microphone and receiver
• clear LCD screen for easy operation

Overview and use

5.
Refer to the illustrations on page 2 of this manual.
1 Channel A frequency UP & auto search button
2 Power pushbutton
3 Channel A frequency DOWN & IR button
4 Channel A setting & confirmation button
5 Channel A volume control
6 LCD screen
7 IR transmitter LED
8 Channel B volume control
9 Channel B setting & confirmation button
10 Channel B frequency DOWN & IR button
11 Channel B frequency UP & auto search button
12 Antenna socket B
13 Channel B receiver sensitivity adjustment (SQL-B)
14 Channel B balanced output
15 A+B unbalanced output (MIXED)
16 Channel A balanced output
17 Channel A receiver sensitivity adjustment (SQL-A)
18 Power jack
19 Antenna socket A
1 RF (radio signal strength) indicator
2 AF (audio level) indicator
3 Mute indicator: when "MUTE" is displayed the system is not receiving any vocal signal or the
transmitter mute button is pushed.
4 frequency display shows the set operating frequencies.
5 Diversity signal receiving indicator A: if antenna A is the strongest receiving antenna, "A" is
displayed.
6 Diversity signal receiving indicator B: if antenna B is the strongest receiving antenna, "B" is
displayed.
7 Channel display
8 Automatic Channel Targeting (ACT) indicator
1 Power switch: to turn the microphone on, press and hold the "MUTE" button [1] for ±3 seconds,
until the indicator LED [5] lights up green. The green LED starts flashing and then switches to red
when the microphone is ready for use. The start-up routine takes ±15 seconds. To switch off,
press and hold the "MUTE" button [1] for ±3 seconds until the indicator LED [5] is off.
To mute the sound signal: push the mute button [1] briefly, the LED [5] turns green and the
audio signal is muted (the LCD display shows "mute" [3]). To return to normal operation, push
the mute button again (briefly). The LED [5] turns red and the audio signal is transmitted.
2 ACT IR receiver
3 capsule and grill
4 Battery compartment
5 indicator LED
red - flashing
green - flashing
red – fixed
green – fixed
15/07/2011
MICW48
Receiver
Display
Microphone
replace batteries
ACT function active
microphone is transmitting audio
microphone is not transmitting audio (muted)
5
Rev. 02
©Velleman ® nv