Basic Operations; Basic Playback; To Play A Disc; To Stop Playing Disc - Singing Machine SMI-1222 Manual De Instrucciones

BASIC OPERATIONS

BEFORE PLAYING
!
Please check "Playable Discs" to make sure the disc is playable.
!
Make sure the Singing Machine is connected to the components properly and the power of the Singing Machine
and the other components are on.

BASIC PLAYBACK

TO PLAY A DISC

1. Press the POWER button on the machine to turn
on the unit.
2. Adjusts the FUNCTION knob on the machine
until DVD appears on the LED of your Singing
Machine.
3. Press the Door Open button on the unit to open
the disc compartment.
4. Place a disc into the compartment and close the
disc door. Make sure the disc is position properly
with the label side up.
5. Press the PLAY/PAUSE button to start playing the
disc.
NOTE:
1. For some discs, playback will start from the first
chapter or track of the disc automatically.
2. When you playback a DVD which a title menu is
recorded, it may appear on the screen. In this
case, refer to " TITLE
3. For a picture CD disc, a slide show will begin if
play button is being pressed.
CAUTION: Keep your fingers away from the disc tray
as it is closing. Neglecting to do so may
cause serious personal injury.
TO STOP PLAYING A DISC
1. Press the STOP button to stop the disc from
playing. A blue screen with The Singing Machine
logo will appear on your TV screen. "Press PLAY
Key To Continuous" picture will appear on the TV
screen.
2. Press PLAY/PAUSE to resume playback. The
playback starts from where the STOP button is
pressed.
NOTE:
1. Pressing the STOP button again after the disc
stops playing will clear the location index stored in
memory.
DVD - Playback starts from the beginning of the
current title.
CDG/CD - Playback starts from the beginning of
the disc.
2. For picture CD discs, no location index stored in
memory if you press the STOP button.

TO REMOVE A DISC

1. Switch the function to AUX or TAPE.
2. Wait for disc to stop spinning.
3. Press DVD Door Open button to access the CD,
DVD etc.
4. Remove the disc from the compartment.
5. Press the CLOSE point (on the door) again to
close the compartment.
" section.
TO GO TO NEXT AND PREVIOUS
CHAPTER/ TRACK
For DVD disc: Pressing PRE
1.
button can go to the next or previous chapter on
the disc.
2 For CDG/CD disc: Pressing NEXT
.
aaa button will enable you to go to the next or
previous track on the disc.
3. For picture CD disc: Next or Previous file will be
shown if NEXT/PRE button is pressed.
NOTE:
1. When PRE aaa
normal playback of DVD, the chapter being
played will be played from the beginning.
2. Input the index of the chapter or track by pressing
the NUMBER buttons during the normal
playback, the playback will go to that chapter or
track directly.
TO PLAY IN FAST REVERSE OR FAST
FORWARD
1. During normal playback of a DVD or CD, press
FWD button to fast forward and press REV to fast
reverse.
2. Each time you press either button it will change
the playback speed. The following sequence will
appear on screen.
FWD: 2X 4X 8X 16X 32X Normal Play
(It will not display on screen)
REV: 2X 4X 8X 16X 32X Normal Play
(It will not display on screen)
The rate and direction of playback is indicated on
the display.
3. Press the PLAY button to return to normal
playback.
NOTE:
1. This function is not available for CDG and picture
CD discs.
2. The Singing Machine omits the subtitle and mutes
sound during fast forward or fast reverse mode.
3. The speed of the fast forward or fast reverse may
differ depending on the disc.

TO PAUSE PLAYBACK (STILL MODE)

1. Press the PLAY/PAUSE button during playback.
2. Press the PLAY/PAUSE button again to resume
playback.
NOTE:
1. This function is available for all discs.
2. The sound is muted during this mode.

VOLUME CONTROL

Rotating the Volume knob will adjust the audio up or
down.
E20
aaa or NEXT
aaa or PRE
button is pressed once during
aaa