Device Description - AL-KO TE 450 Manual Del Usuario

Electrical safety notes
The mains voltage must correspond with the
voltage that is specified on the technical data
plate. Do not use any other mains voltage.
The power outlet should be protected with a
fault-current circuit breaker with a current of not
more than 30mA. Consult an electrician.
Use the cable suspension / cable relief device
provided for fixing the extension cable.
Do not use the trimmer in rain. Avoid exposing
the trimmer to wet or humid surrounding. Do not
leave the trimmer outdoors overnight. Do not cut
humid or wet grass.
To make sure that the extension cable is not
damaged, avoid hovering over the cable with a
running trimmer. Always keep it in a safe position
behind your back.
Use only the extension cable, 3x1.5 mm², of the
quality H07RN-F according to DIN 57282/57245
with splash-proof plug. Cable drums must be
fully rolled out. Maximum cable length is 70 m.
Keep it in a cutting area away from humid, wet,
oil-smeared surfaces, as well as from sharp
edges, heat sources and fuels.
Prior to using the trimmer each time, ensure that
the extension cable is intact.
Children must be kept away from trimmers
connected to the mains.
Application purpose
Appropriate application
The line trimmer is exclusively meant for private
use, for trimming lawn edges on the ground.
Inappropriate application
Cutting scrub and weed or large-area lawns is
not considered as inappropriate application.
Any other application not expressly permitted in
these instructions can lead to damage to the
trimmer and pose a serious danger to the user.
The manufacturer/supplier is not liable for any
resulting damage. The user is solely responsible
for the risk.

Device description

Line trimmer / accessory (Figure A)
1 Top handle
2 Switch
3 Cable grip
4 Integrated trimmer plug
5 Additional handle
6 Bag for keeping the line
7 Trimmer shaft
8 Cutting head with motor
9 Venting slots
10 Adjusting lever (only TE600)
11 Protection device
12 Bracket (only TE600)
13 Line spool
14 Housing for line spool
15 Cutting-edge guide wheel (only TE600)
16 Line cut-off blade
Designation and symbols (Figure B
1 Equipment make and model
2 Item number
3 Series number
4 Technical data
5 Certification marks
TE450/TE600, adjustable telescopic
shaft
The telescopic shaft is used to adjust the trimmer
to match your individual body size.
•
Rotate the fastening sleeve (Figure J/c, I2/c)
on the handle by approx. 180° towards the
right side and then pull the tube and handle
apart. In that way, you can lengthen the
trimmer by approx. 10 cm. (Figure J/d, I2/d).
TE 600, swing-out type motor head
The trimmer TE 600 is equipped with a swing-out
type motor head. The guide tube can be turned
through 180 °, and be changed in length. The
inclination angle of the motor can be changed
(Figure I).
With a changed inclination angle, you can also
trim inaccessible points, e.g. under benches,
protrusions, etc.
•
To change the inclination angle, press the
adjusting lever
(Fig. I 1/a) and incline the tube (Fig. I1/b) by
25° or 50°.
)
in the motor housing
GB 2