Function Table - Waeco MagicTouch MT350 Instrucciones De Montaje

Using MagicTouch
8 Using MagicTouch
8.1

Function table

The following table lists all of the functions and how you can activate them.
Function
Closing the central locking
system
Opening the central locking
system
Convenience function
Programming
●
Press the appropriate button
● *) Press both buttons at the same time
8.2 Setting the radio receiver
Note
I
For the radio receiver to recognise new settings, you must first pull out the
connection plug.
Set the DIP switches (fig. 4, page 4) on the radio receiver according to the following
table:
DIP switch Meaning
1 Sets the activation time
for the central locking
system.
2 Sets the control function
of the convenience out-
put.
60
Condition
–
–
Ignition switched off
Ignition switched on
"Off" position
The central locking sys-
tem is activated for 0.6 s.
This position applies to
all central locking sys-
tems that require less
than 0.6 s for the locking
operation.
After pressing button 1,
the convenience output
is active for 10 s.
MagicTouch MT350
Left- Right-
hand hand
blue but- blue but-
ton ton
●
●
● *) ● *)
"On" position
The central locking sys-
tem is activated for 3.5 s.
This setting is required
by some central locking
systems that work pneu-
matically and require
more than 0.6 s for the
locking operation.
The convenience output
is activated for 10 s only
by pressing the grey but-
ton.
Grey
button
●