Replacing The Battery - Waeco MagicTouch MT350 Instrucciones De Montaje

Using MagicTouch
– Connect the other side of the 15 A fuse element to terminal 30 (+12 V).
– Connect the second red cable at contact 30 to the red cable at contact 86.
– Connect the green/red cable for MT350 to contact 85.
– Connect the black cable at contact 87 to the original vehicle cable that comes
from the light switch and switches the positive dimmed headlight signal.
Automatic re-locking of the central locking system
If the hand transmitter is operated unintentionally (central locking opens) without any
door being opened, the central locking system closes again after roughly a minute. If
you do not want to use this function: refer to the description of connections on
page 52.
Safety locking
If the ignition is switched on, the central locking system can be locked using the hand
transmitter. In doing so, the indicators are not activated.
The central locking system can be re-opened using the hand transmitter or by switch-
ing off the ignition. This function is not supported by all vehicle models.
8.4

Replacing the battery

If the hand transmitter's range is reduced noticeably or if the LED flickers during
transmission, the battery needs to be replaced.
Please observe the following instructions for batteries:
Warning!
d
Keep the batteries out of reach of children.
Only use leak-proof batteries that are suitable for electronic devices.
Never attempt to
– recharge or open
– batteries or throw
– them in fires.
62
MagicTouch MT350