Settings From The Mode Button - Sime HOME PLUS Manual De Instalacion Y Uso

EN
System inertia
This is a parameter which adjusts the reaction time of the ad-
justment algorithm, to be associated with inertia or with the
size and type of building and the heating system.
Flow Temp. min. set
It is the lower limit of the calculated flow temperature (use-
ful in the case of low efficiency systems with low calculated
temperatures)
Antifreeze enable
YES setting : enable the antifreeze protection program
NO setting: the heating will remain off when in the function
mode OFF, SUMMER and in periods of Reduced mode AUTO if
the room sensor is disabled.
Antifreeze set
This is the room temperature (antifreeze) below which the de-
vice makes a heating request at the minimum flow set. The
request remains active until the room temperature has ex-
ceeded the "antifreeze temperature + 0.6°C"
Room probe offset
This is the value used to correct the room temperature read-
ing by the sensor inside the device.
Anti-legionella Function
This is the function used to protect against the development of
bacteria in the water. There are three possible settings - Acti-
vation - Day - Time.
4.3

Settings from the MODE button

From the "main screen"
Zona
Menu
– Press the button Mode
Rotate the encoder
"Function mode".
Mode (eg. "Winter")
Summer
Hot water
Heating
Holiday function
Esc
– Press the encoder to confirm the highlighted "Mode"
click
and go into the "rows"
Hot water
Heating
Holiday function
Esc
– Rotate the encoder to select "Heating"
Gi 18 Set 2014 10:30
Off
Modo
to go into the screen to select
to select one
Winter Off
MAN 40°C
MAN 20.0°C
OFF
Back
Winter
MAN 40°C
MAN 20.0°C
OFF
Back
47