Mounting The Device - HQ-Power VDPL2201MHW10 Manual Del Usuario

Moving head con leds - efecto wash
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

• Familiarize yourself with the functions of the device before actually using it. Do not allow operation by unqualified
people. Any damage that may occur will most probably be due to unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
crash, etc. Using the device in an unauthorized way will void the warranty.

4. Mounting the Device

• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• The carrying construction must be able to support 10 times the weight of the device for 1 hour without deforming.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorized persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install the
device yourself if you lack these qualifications as improper installation may result in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 0.5m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
5. Use
Switch the device on and off by means of the power plug. Do not operate the device continuously.
a. Channel Configuration
CHANNEL 1: Pan
CHANNEL 2: Tilt
CHANNEL 3: Pan / Tilt speed
CHANNEL 4: Red
CHANNEL 5: Green
CHANNEL 6: Blue
CHANNEL 7: LED macro
CHANNEL 8: LED speed
CHANNEL 9: Shutter
CHANNEL 10: Dimmer
b. Detailed DMX Values per Channel
CHANNEL 1
CHANNEL 2
CHANNEL 3
CHANNEL 4
CHANNEL 5
CHANNEL 6
VDPL2201MHW10
Description
From
Pan
Tilt
Pan / Tilt speed
Red
Green
Blue
To
Function
0
255
0 – 540°
0
255
0 – 270°
0
255
Pan / tilt speed control
0
255
0 – 100%
0
255
0 – 100%
0
255
0 – 100%
4
HQ POWER

Publicidad

Tabla de contenido
loading

Tabla de contenido