HQ-Power VDPL2201MHW10 Manual Del Usuario página 5

Moving head con leds - efecto wash
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

CHANNEL 7
CHANNEL 8
CHANNEL 9
CHANNEL 10
c. DMX512 Connection
Connect the provided XLR cable to the female 3-pin XLR output of your controller and the other side to the male 3-
pin XLR input of the VDPL2201MHW10. Multiple VDPL2201MHW10s can be linked through serial linking. The
linking cable should be a two-core screened cable with XLR input and output connectors.
Pin assignment: pin 1: shield – pin 2: data+ – pin 3: data-
d. DMX-512 Chain with Termination
e. Projector DMX Start Address Selection
All DMX-controlled devices need a digital start address so that the correct device responds to the signals. This start
address is the channel number from which the device starts to "listen" to the DMX controller. Enter the correct
number and read it from the display located on the base of the VDPL2201MHW10.
You can use the same starting address for a whole group of devices or enter an individual one for every device.
When all devices have the same address, all the VDPL2201MHW10s will "listen" to the control signal on one
particular channel. In other words: changing the settings of one channel will affect all devices simultaneously. If you
set different addresses, each device will "listen" to a separate channel number. Changing the settings of one channel
will only affect the device in question.
In the case of the 10-channel VDPL2201MHW10, you will have to set the start address of the first
VDPL2201MHW10 to 1, the second VDPL2201MHW10 to 11 (1 + 10), the third to 21 (11 + 10) and so on.
VDPL2201MHW10
LED macro
LED speed
Shutter
Dimmer
A DMX terminator is recommended for installations where the DMX cable has to run a
long distance or is in an electrically noisy environment (e.g. discos). The terminator
prevents corruption of the digital control signal by electrical noise. The DMX terminator is
simply an XLR plug with a 120 resistor between pins 2 and 3, which is then plugged into
the XLR output socket of the last device in the chain.
Please see illustrations.
0
7
No function
8
22
Magenta
23
37
Purple
38
52
Orange
53
67
Pink
68
82
Yellow
83
97
Green
98
112
Turquoise
113
127
Light green
128
142
Sky blue
143
157
Navy blue
158
172
Chartreuse
173
187
Cyan
188
202
White
203
215
Auto chase 1
216
228
Auto chase 2
229
241
Auto chase 3
242
255
Auto chase 4
0
255
Colour changing with speed adjustment
0
7
Open
8
231
Strobe effect 0 – 100%
234
255
Open
0
255
100 – 0%
5
HQ POWER

Publicidad

Tabla de contenido
loading

Tabla de contenido