Listening To Phono; Aux-In Connection - auna TT-92W Manual De Usario

EN
22

LISTENING TO PHONO

• Remove the stylus protector.
• Be sure that the tone arm is being detached from the tone arm rest
before operating and re-secured again after wards.
1 Select to "Phono" function from Function Selector(5)
2 Set the speed selector to the proper position depending on the record
to be played.
3 Place the record on the platter(use the Spindle Adaptor if required).
4 Lift the tone arm from the rest and slowly move it to the record side.
5 The platter will start to rotate.
6 Place the tone arm to the desired position of the record.
7 Adjust the volume to the desired level.
8 At the end of the record, the platter will automatically stop rotating.
9 Lift the tone arm from the record and return to the rest.
10 To stop manually, lift the tone arm from the record and return it to the
rest.
Remark
As some kind of record the auto-stop area was out of the unit setting, so
it will stop before the last track finish. In this case, select the Auto-Stop
Switch (22) to "Off" position. Then it will run to the end of the record but
will not stop automatically.(Turn off the unit by power button or switch
back the Auto-Stop Switch (22) to "On" position to stop the platter rotate).
Then put back the tone arm to the rest position. Due to Aux and Phono
were designed at the same po- sition of this system. When Aux in jack(24)
plugged by 3.5mm plug. The channel will change to Aux automatically and
turntable will stop to ro- tate. Please ensure the Aux in jack (24) without
plugged by anything before playing Phono.

AUX-IN CONNECTION

1 Slide the Function knob(5) to Phono/Aux position.
2 Adjust the Power ON-OFF/ Volume Control Knob(16) to desired volume
level.
3 Start to play your external device