GE JKS10-27 Manual Del Usuario página 16

Care and cleaning of the oven.
I I SHOCKORBURNHAZARD.Before replacing oven light bulb, disconnect the electrical
A__ WARNING Imower to the oven at t he m ain fuse or c ircuit breaker _anel. Failure to do so may result
in electric shock or burn.
I I BURN HAZARD.Theglass cover and bulb should be removed when cool. Touchinghot glass
A CAUTION with b are hands or a damn clot/, can c ause burns.
Fleceetacle ,
Socket
Oven Light Replacement
on somemodels
Receetacle Socket
Bull:
Glasscover
(onsomemodels)
Toremove:
[Z] Turn the _ass cover
counterclockwise 1/4 ulrn until
the tabs of the Mass cover cleat the
grooves of the socket. XYearing latex
gloves may offbr a better grip.
[]
Using gloves or a dry cloth, remove
the bulb by pulling it straight out.
Toreplace:
[Z] Use a new 120/130-volt halogen
bulb, not to exceed 50 watts.
Replace the bulb with the same
type of bulb that was removed. Your
model will have one of the two types
shown on the left. To demrmine the
correct replacement bulb, check the
bulb mrminals. Bulbs with 2 smdght
pin terminals are G6.35 bulbs. Bulbs
with 2 looped terminals are (7;9
bulbs. (Donot interchange.)Be sure
the replacement bulb is rated 120
volts or 130 volts (NOT 12 volts).
Using gloves or adD' cloth, remove
the bulb flom its packaging. Do not
touch the bulb with bare finget_. Oil
fiom skin will damage the bulb and
shorten its life.
Receptacle
%
Use gloves
0_ €_0th
/
Push the bulb straight into the
receptacle all the way.
Place the robs of the ,glass cover into
the grooves of the socket. Turn the
glass cover clockwise 1/4 utm.
For improved lighting inside
die oven, clean the glass cover
frequently using a wet cloth. This
should be done when the oven is
complemly cool.
Reconnect electrical power to
the oven.
Oven Light Bulb (onsomemodels)
NOTE." T heglasscover (onsomemodels) s hould
beremoved onlywhencold.Wearing latexgloves
mayoffera bettergrip.
Before replacing file bulb, disconnect
elecuJcM power to file oven at the mMn
fuse or circuit breaker panel. Let the
bulb cool complemly before removing it.
For your safer)5 do not much a hot bulb
with a damp cloth. If you do, the bulb
will break.
G!asscover TOremove:
Turn the glass cover counmrclockwise
1/4 atrn until the tabs of the glass cover
cleat the grooves of the socket. Remove
the bulb.
16
Toreplace:
Put in a new 40-watt appliance bulb.
Place the tabs of the glass cover into the
grooves of the socket. Turn the glass
cover clockwise 1/4 utm.
NOTE:
_, A 40-wattappliance bulbissmallerthana
standard 40-watthousehold b ulb.
, Instaflandtightenthecover clockwise.
, Reconnect electrical p owertotheoven.
Forimproved lightingbside theoven, c lean
theglasscoverfrequently usbga wet cloth.
This shouldbe donewhentheovenis
completely c ool.