GE JKS10-27 Manual Del Usuario página 18

Before you call for service...
Troubleshooting -tips
..... i!liii!!iliiilWiiiii!liH
Oven temperature too
hot or too cold
Possible Causes
Oven thermostat
needs adjustment.
What To Do
* See the Adjust the oven thermostat--Do it yourself!
section.
Oven willnot work A fuse in your home may • Replace the fi]se o1 reset the circuit breakeL
be blown or the circuit
breaker tripped.
Oven controls improperly set. • See the Using the oven section.
"F--- and a number
You have a function
• Press the CLEAR/OFFpad. Allow the oven to cool for
or letter"flash error code. one houL Put the oven back into operation.
in the display If the function code • Disconnect all power to the oven for at least 30
repeats, seconds and then reconnect power. If the flmction
error code repeats, call for service.
Display goes blank A fuse in your home may be • Replace the filse or reset the circuit breakeL
blown or the circuit
breaker tripped.
The clock is in the • See the
Special features of your oven control
section.
black-out mode.
Display flashes Power failure. • Reset the clock.
Oven control pads were not • The BAKE and BROIL HI/LO pads must be pressed at
display
to
show "SF"
pressed properly, the same time and held for 3 seconds.
Power outage.
Power outage or surge. • Reset the clock. If the oven was in use, you must reset
it by pressing the CLEAR/OFF pad, setting the clock
and resetting any cooking fimction.
An odor from the insulation • This is temporary.
around the inside of the
oven is normal for the first
few times the oven is used.
Fan noise
A cooling fan may
automatically turn on.
• This is normal. The cooling fan will mrn on to
cool internal parts. It may run for up to 2 hours
after the oven is turned off.
18