Controls - GE JKS10-27 Manual Del Usuario

Usingthe clock and timer. OEApplia, oes.oom
Make sure the clock is set to the
correct time of day.
To Set the Clock
The clock must be set to the
conect
time
of day for the automatic oven tilning
flmcfions to work properly. The dine of
day cannot be changed during a delayed
cooking cycle.
[7] Press the CLOCKpad twice.
[_] Press the + or - pads.
If fl_e ÷ or - pads are not pressed Mfldn
one minute after you press file CLOCK
pad, the displ W reverts to the original
setting, ff this happens, press the CLOCK
pad twice and reenter the time of day.
[_] Press the START/ON pad until the
time of day shows in the display. This
enters the time and suuts the clock.
Tocheckthetimeof daywhenthedisplay is
showing otherbformation, s implypressthe
CLOCK pad.Thetime ofdayshowsuntilanother
pad ispressed.
To Turn Off the Clock Display
If you have several clocks in your kitchen,
you may wish to mm off"the time of day
clock display on your range.
%
Press the CLOCKpad once to
ttlI'll
off the time of day display. Although
you will not be able to see it, the
clock maintains the correct time
of day.
[] Press the CLOCKpad twice to recall
the clock display.
To Set the Timer
Thetimerdoesnotcontrolovenoperations.
Themaximum settbg on thetimeris9 hours
and59 minutes.
The timer is a minute timer only. III
The timer does not control oven
operations. The maximum setting on
FS]
the timer is 9 hours and 59 minutes. I_1
Press the KITCHENTIMERON/OFF
pad.
Press the ÷ or - pads until the
amount of time you want shows in
the displa).: The maximum time that
can be entered in minutes is 59.
Times more than 59 minums should
be changed m hours and minums.
If youmake a mistake, presstheKITCHEN
TIMERON/OFF pad andbeginagab.
%
Press the START/ON pad. The time
will start counting down, _dthough
the display does not change until
one minute has passed.
When the timer reaches :00, the
control will beep 3 times followed
by one beep every 6 seconds until
the KITCHEN TIMER ON/OFF pad is
pressed.
To Reset the Timer
If file display is sdll showing file time
remaining, you may change it by pressing
the KITCHEN TIMER ON/OFF pad, then
pressing the + or - pads until the time
you want appea_s in the display.
If file remaining time is not in file display
(clock, delay start set time or cooking
time are in the display), recall file
remaining time by pressing
file KITCHEN
TIMER ON/OFFpad and then pressing
the + or - pads to enter the new time
you want.
To Cancel the timer
Press the KITCHEN TIMERON/OFF pad
twice.
9