Removing The Bicycle Seat From Your Bicycle; Removing The Frame Mounting Assembly; Removing The Mounting Rails - Burley DASH FM Manual De Instrucciones Y Seguridad Del Propietario

Removing the Bicycle Seat from Your Bicycle

1. Detach the Safety Strap by releasing the buckle.
2. Remove the Mounting Rails from the Mounting Block by depressing the front face of the
mounting block [Figure 37a] and pulling the Mounting Rails out of the Mounting Block [Figure
37b].
NOTE: It is easiest to remove the Mounting Rails from the Mounting Block if you grab the front
of the Bicycle Seat between the legs (where the Mounting Rails pass through the Bicycle Seat)
Removing the Frame Mounting Assembly from Your Bicycle
1. Remove the Mounting Plate from the Mounting Block by using the provided Hex Wrench to
remove the 4 screws, while being careful not to lose the lock washers.
2. Remove the Mounting Block from the bicycle frame.
Removing the Mounting Rails from Your Bicycle Seat
1a. Dash FM: Remove the Mounting Knob by pulling the Locking Ring towards the Mounting Knob
[Figure 38a], and rotating the Mounting Knob counter-clockwise [Figure 38b].
1b. Dash X FM: Remove the bolt by using the included Hex Wrench to rotate it counter-clockwise
[Figure 39].
2. Rotate the Base Plate away from the seat [Figure 40a] and then slide the Mounting Rails out
through the 2 holes between the legs of the Bicycle Seat [Figure 40b].
A
Figure 37
OWNER'S INSTRUCTION & SAFETY MANUAL
Figure 39
B
Figure 38
A
Figure 40
BURLEY.COM
A
B
21
ENG