Preparing The Installation Cavity - Thermador T36IB Serie Instrucciones De Instalación

6.

Preparing the installation cavity

m
WARNING
Assure that there are no electrical wires or plumbing in
the area which the screws could penetrate.
Risk of injury and damage!
NOTE
– 2 anti-tip-angless are required for each appliance or
appliance combination (Side-by-Side).
– The supplied set contains fastening screws for
various applications. Select the fastening screws
according to the local conditions.
– If the supplied fastening screws do not permit
secure attachment of the anti-tip brackets and
therefore the appliance, another method must be
used to attach the anti-tip brackets securely.
The anti-tip-angles must have a minimum length of 4
(105 mm) over the appliance to ensure a secure stand of the
appliance.
If this minimum length cannot be observed for structural
conditions it is possible to do this by fastening a spacer
behind the anti-tip angle, e. g. a sufficiently dimensioned
wood plank.
The length of the plank should correspond to the width of the
installation niche!
̈
Specify the attachment points of the anti-tip-angles.
Specify the detailed dimensions according to the
section on "Installation dimensions".
̈
Attach the anti-tip-angles completely. Be sure screws
hold tight.
18
Fastening with wood screws
m
Fastening with dowels and screws
m
Always wear safety glasses and other necessary pro-
tective devices or apparel when installing or working
with anchors.
Risk of injury!
Not recommended for use in light-weight masonry material
such as block or brick.
1
/ "
8
Not recommended for use in new concrete which has not
had time to cure.
Do not use core drills to drill holes for this anchor.
CAUTION
m