Sensor Parameter Adjustment; Set Up Bluetooth Connection With Pc/ Notebook; Preparations - Vega VEGAPULS WL S 61 Manual De Instrucciones

After successful authentication, the next con-
nection functions without authentication.
iOS
During the pairing process, the following mes-
sage is displayed: "Pairing request (Bluetooth),
e.g. 12345678 wants to pair with your iPad".
Press "Pair".
Android
The coupling passes through automatically.
Enter PIN
For authentication, enter in the next menu win-
dow the 4-digit PIN. You can find this PIN on:
•
Type label support on sensor cable
•
The front page of the operating instructions
Note:
If an incorrect sensor PIN is entered,
the PIN can only be entered again after
a delay time. This time gets longer after
each incorrect entry.
The message "Waiting for authentication" is
displayed on the smartphone/tablet.
Connected
After connection, the sensor adjustment menu
is displayed on the respective adjustment
instrument.
If the connection is interrupted, e.g. due to a too
large distance between sensor and operating
device, this is displayed on the operating device.
The message disappears when the connection
is restored.
Change sensor PIN
It is recommended to change the default setting
of the sensor PIN to your own sensor PIN. To do
this, go to the menu item "Lock adjustment".
After the sensor PIN has been changed, sensor
adjustment can be enabled again. For access
(authentication) with Bluetooth, the PIN is still
effective.
VEGAPULS WL S 61 • 4 ... 20 mA
7 Set up Bluetooth connection with PC/notebook
6.3 Sensor parameter
adjustment
Enter parameters
The sensor adjustment menu is divided into two
halves:
On the left you'll find the navigation section with
the menus "Setup", "Display", "Diagnosis" and
others.
The selected menu item, recognisable by the
colour change, is displayed in the right half.
Abb. 26: Example of an app view - Setup sensor
adjustment
Enter the requested parameters and confirm via
the keyboard or the editing field. The settings
are then active in the sensor.
Close the app to terminate connection.
7 Set up Bluetooth connec-
tion with PC/notebook
7.1

Preparations

System requirements
Make sure that your PC meets the following
system requirements:
•
Operating system Windows
•
DTM Collection 10/2016 or higher
•
USB 2.0 interface
•
Bluetooth USB adapter
Activate Bluetooth USB adapter
Activate the Bluetooth USB adapter via the
VEGA project assistant (see supplementary
instructions "Bluetooth USB adapter"). Sensors
with Bluetooth capable PLICSCOM will be
found and a project tree created.
29