Rupes LHR 75 Instrucciones De Uso página 9

PARTS OF THE TOOL
1 - Identification plate
2 - On/off switch
3 - Speed control
4 - Tool body
5 - Velcroed disc pad
6 - Polishing pad (not supplied)
7 - Air inlet fitting (not supplied)
8 - On-off lever safety lock
9 - Back-up pad release spanner
10 - Back-up pad screw
11 - Air outlet hose/silencer
12 - Silencer
STARTING UP
Before starting-up the tool, ensure that:
- the packaging is complete and does not show signs of ha-
ving been damaged during storage or transport;
- the tool is complete; check that the number and type of compo-
nents comply with that reported in this instruction booklet;
- the available compressed air production and distribution
plant is capable of satisfying the requirements reported on
the tool's identification plate reproduced and explained on
page 11.
ASSEMBLING THE TOOL
Assemble the compressed air connection (not supplied) by
screwing it into its seating (7).
COMPRESSED AIR CONNECTION (NOT SUPPLIED)
The tool is supplied without the compressed air connection.
The user can use either a quick release coupling: or hose type
connection according to his needs purke that have an hole air
passing mm 8.
In the latter case the air line must be fixed to the nozzle by a
hose clip.
REMOVING AND MOUNTING THE DISC PAD
- Use the spanner (9) to unscrew the back-up pad bolt;
- reverse the procedure when fitting the disc pad.
ASSEMBLING THE POLISHING PAD
Press the polishing pad to attach it to the back-up pad.
BEFORE STARTING THE TOOL
Ensure that:
- the compressed air feed line and connection are in perfect
working order;
- the start lever is working properly. This must be done with
the air supply switched off;
- all the components of the tool are mounted correctly and do
not show any signs of damage.
STARTING AND STOPPING
- Starting: push the control lever (5) forward towards the body
ofthe tool and keep it pressed.
- Stopping: release the knob.
TEST RUN
Turn the tool on and check the correct back-up pad and buffer
assembling and check for unusual vibration
Otherwise switch-off the tool immediately and eliminate
the cause.
9