Before Starting Engine - Garland CHIPPER 500 G Manual De Instrucciones

Transporting the shredder:
- Place yourself behind the shredder.
- Hold on to the handle and place pressure on the
wheel axis.
- Pull back and move using wheels.

BEFORE STARTING ENGINE

Oil:
- Place the machine on a stable place with the
engine level. Unscrew the cap / dipstick and put
20W-40 multigrade oil to the maximum level of the
rod (0.6L tank capacity approx.) And screw the cap
tightly to prevent leakage.
Oil level indicator stick
Max.
Min.
Oil level control:
WARNING!
RUNNING ENGINE WITH INSUFFICIENT OIL WILL
CAUSE SERIOUS ENGINE DAMAGE.
WARNING!
WHEN CHECKING OIL STOP ENGINE AND PLACE IT
ON A LEVEL SURFACE.
- Remove dipstick and wipe clean with cloth.
- Replace dipstick back without lock it in. Pull the
dipstick out and check the oil level.
- Oil level should be at upper limit on dipstick.
- If the oil level is near or below the lower limit mark
on the dipstick, add oil slowly and recheck until oil
level reaches upper limit of dipstick. DO not overfill.
- Replace the stopper and close it by tightening it.
WARNING!
USING DIRTY OIL OR TWO-STROKE ENGINE OIL WILL
SHORTEN ENGINE USEFUL LIFE.
Fuel:
- The engine is certified to operate on unleaded
petrol with a minimum of 85 octane. Fresh fuel
prevents gum from forming in the fuel system.
- Do not mix oil with petrol.
- Keep dust, water and foreign matter away from
fuel system.
- Do not use gasoline which contains Methanol.
- Only use containers with certificates to contain
petrol.
WARNING!
GAS IS EXTREMELY FLAMMABLE; IT WILL EXPLODE
IF EXPOSED TO A SOURCE OF IGNITION.
23/52
English