GE P2S975 Manual Del Propietário página 34

Before you call for service...
Troubleshooting -tips
Save time and money! Review the charts on the following
pages first and you may not need to call for service.
Possible Causes
Burners have yellow or The combustion quality of
yellow-tipped flames burner flmnes needs to be
determhmd visually.
What To Do
• Use the illustrations below to detemfine ifvour burner
flaules are nomml. If burner flaules look like ,4, call fin.
service. Nomml burner flames should look like B or 12,
depending on the t},l)e of gas you use. With I,P gas, some
yellow fii)ping
on OtlteY cones is nOlillal.
ii
A-Yellow flames B-Yellow tips C-Soft blue flames
Call for service on outer cones Normal for natural
Normal for LPgas gas
Control knobs Knob isn't pushed down. * To turn from the OFF position, push the knob in and
will not turn
then turn.
Burners do notlight
Range Lock-Out feature is * Pdlow the range to cool down and touch and hold the
activated. RANGE LOCK-OUTpad lot 3 seconds until the display
shows LOC OFF.
Plug on range is not * Make sure electrical l)lug, is I)lugged,, into a live, prol)erly
completely inserted in the grotmded outlet.
electrical outlet.
Gas supply not cmmected • See the Installation Instructions that came with your
or turned on, l':ln re
A fuse in your home may be * Rel)lace the fl/se or reset the circuit breakel:
blown or the circuit breaker
tripped.
Burner parts not replaced * See the Care and cleaning of the range secdon.
correctly.
Range Lock-Out feature ,, It LOC ONal)l)ears
in the display, the range, control is
is activated h)cked. Turn this feature ott to use the ran _e See the
Range Lock-Out section.
Ticking sound ofspark Control knob is still * Turn the knob out of the LITE position to the desired
igniter persists after in the LITE position, settiu
burner lights * Turn
the burner
oft :rod relight.
]f ticking is still
l)resent, call ti)r service.
Burner flames very hnproper air to gas ratio. * /f range is connected to LP gas, check :111steps
large or yellow
in the Installation Instructions that came with
VOlU" 1":111 re
Oven light does Light bulb is loose or defective. " Tighten or replace the btflb.
net work
Switch operating * Call for service.
light is broken.
Oven willnot work Plug on range is not completely * Make sure electrical l)lug, is I)lugged,, into a live, l)roperly
inserted in the electrical outlet, grotmded outlet.
A fuse in your home may * Replace
the tuse or reset the circtfit breakel:
be blown or the circuit
breaker tripped.
094 Oven controls improperly set. * See the Using the oven section.