Troubleshooting Tips - GE P2S975 Manual Del Propietário

Before you call for service...
Troubleshooting tips
Possible Causes What To Do
Clockand timerdo Plug on range is slot completely * Make sure electrical l)lug, is l)htgged,, into a live, properly
not work i_serted ha the electrical outlet, grounded outlet.
A fuse ha your home
* 14eplace tile fl/se or reset tile circuit bl'eakel:
may be blown or the
circuit breaker tripped.
Oven controls improperly set. * See the Using the clock and timer section.
Oven will not self-clean
Surface burner is on.
* Turn all surtilce
1)twne_
off.
The oven temperature is
* _Mh)w the range to cool and reset the controls.
too high to set a self-clema
operation.
Oven controls improperly set. * See the Using the self-cleaning oven section.
The probe is plugged into • I_eusove the probe from the oven.
the outlet in the oven.
"Crackling" or This is the sound of the * This is normal.
"popping" sound
metal heating and cooling
during both the cooking and
clemfing functions.
Excessive smoking Excessive soil. * T(>t/( h tile CLEAR/OFFpad. Open the windows t(>
during a clean cycle
rid the room of smoke.
Wait tmtil the LOCKED light
goes off. \,Vipe ttI) the excess soil and reset the
clean
cycle.
Oven door will not Oven too hot. * Allow the ovels to cool below locking rein _erattu'e
open after a clean cycle
Oven not clean after a Oven controls
slot
properly set. * See the Using the self-cleaning oven section.
clean cycle
Oven was heavily soiled. * (]le;llS tip
heavy
spillovers befol'e
starting
the clean
cycle. Heavily soiled (wens may need to sell:clean
again or fin" a lon,_er_ period of time.
"LOCKED"flashes The self-cleml cycle has been * Close the oven door.
in the display
selected hut the door is not
closed.
"LOCKED"light is The oven door is locked * Tot/ch the CLEAR/OFFpad. Alh)w the oven to cool.
on when you want because the temperature
to cook inside the oven has not
dropped below the
locking temperature.
"F---andanumber You have a fmzction error code. *TotlchtheCLEAR/OFFpad. Ptlt the oven l)ack into
orlefter" flash operation.
in the display If the function code repeats. * Disconnect all power to the range, fin" at least 30
seconds
and then
reconnect power. If the flusction
error code repeats, call fi)r service.
36