HQ-Power VDP250MHS18FL2 Manual Del Usuario página 5

• Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install the
device yourself if you lack these qualifications as improper installation may result in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 0.5m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
e) Fasteners
5. Use
a. Menu Settings
Menu
DMX address
Pan rev
Tilt rev
RSLTN
Mix colour
Lamp pow
Test
Info
Default
Reset
VDP250MHS18FL2_v2
Item Function
1 – 512 Set the required address
Yes Backwards pan movement
No Forward pan movement
Yes Backwards tilt movement
No Forward tilt movement
16-bit 16-bit resolution (16 channels)
8-bit 8-bit resolution (14 channels, no fine)
Yes Mix colour function
No No mix possible
Off Lamp OFF
On Lamp ON
Pan 0 – 255 Pan movement test
Tilt 0 – 255 Tilt movement test
Shutter 0 – 255 Shutter test
Dimmer 0 – 255 Dimming test
Colour 0 – 255 Colour test
Zoom 0 – 255 Zoom test
Gobo 0 – 255 Gobo test
R-gobo 0 – 255 R-gobo test
Gobo 2 0 – 255 Gobo 2 test
Prism 0 – 255 Prism test
R-prism 0 – 255 R-prism test
Focus 0 – 255 Focus test
Exit – Exit test menu
Time – –
Version 1.0 Software version
Yes Return to default setting
No Keep current setting
Reset the fixture
5 HQPOWER