Panasonic LUMIX DMW-MCTZ3 Instrucciones De Funcionamiento página 22

Caution for Use
≥
Use only the specified grease. If you use other types of grease, the surface of
the O-ring may be damaged causing water leakage.
≥
The O-ring comes into contact with the sides of the Case making the Case
waterproof. Do not knock, insert foreign materials (dirt, sand, hair etc.) or scratch
the O-ring or sides of the Case.
≥
Use the tips of your fingers to remove the O-ring. Do not use a pointed object as it
may scratch the O-ring.
≥
After removing the O-ring from the rear case, wipe off any dirt, sand, hair or other
foreign materials on it. Also wipe the O-ring groove and the inner sides of the front
case which come into contact with the O-ring.
≥
Never use an O-ring that has been scratched or damaged by dirt etc. This will cause
water leakage. Replace it with a new O-ring.
≥
After replacing an O-ring, not using the Case for a long period of time or opening the
Case to attach a digital camera, replace the battery etc., thoroughly check that the
O-ring is not scratched or split. Then, close the Case and check that no water leaks
into it by submerging it in a water tank, bath tub etc. for about 3 minutes. (P14)
≥
O-rings are consumable products. Although the lifespan of O-rings will depend on
how well they are maintained, how often they are used and their storage conditions,
we recommend replacing them every year even if you cannot see any scratches.
∫
About maintenance
≥
Do not use the chemicals shown below for cleaning, rustproofing, defogging
or repair. Using them directly or indirectly (with a chemical spray etc.) on the
Case may cause it to crack under high pressure.
Prohibited chemicals
Volatile organic solvents/
Chemical cleansers
Anti-corrosives
Anticlouding agents
Adhesives
≥
If grease sticks to the digital camera, wipe it off with a soft, dry cloth.
≥
When wiping the inside of the Case, only use a soft, dry cloth. Wipe the inside of the
front glass with a soft, dry cloth before and after use to keep the glass clear.
22
VQT1F26
(continued)
Do not clean the Case with volatile organic solvents
such as alcohol, gasoline or thinner or with chemical
cleansers. Clean it with fresh water or lukewarm water.
Do not use anti-corrosives as the metal parts of the
Case are made from stainless steel or brass. Clean it
with fresh water.
Do not use commercially available anticlouding
agents. Be sure to use the silica gel indicated in these
operating instructions.
Do not use adhesives for repair. If the Case needs to
be repaired, consult your dealer.
Cautions