Hitachi Koki DH 24PB3 Instrucciones De Manejo página 7

○ 13 mm rotary hammer chuck
For drilling operations when using a straight shank bit for impact drilling with a rotary hammer.
(
Straight shank bit
for impact drill
2. Anchor setting (rotation + hammering)
○ Anchor setting adapter (for rotary hammer)
Anchor setting adapter (SDS-plus shank)
(for rotary hammer)
Overall length: 160, 260 mm
Anchor size
○ Anchor setting adapter (for manual hammer)
Anchor size
3. Large hole boring (rotation + hammering)
○ Center pin, core bit, core bit shank and guide plate.
(Guide plate) Center pin
Center pin
–
Center pin (A)
Center pin (B)
Do not use core bits with
outer diameter of 25 mm and
29 mm.
)
13 mm Rotary hammer chuck
(SDS-plus shank)
Chuck wrench
W1/4"
W5/16"
W3/8"
W1/4"
W5/16"
W3/8"
Anchor setting adapter
W1/2"
(for manual Hammer)
W5/8"
Core bit
Core bit (outer diameter)
(A)
(B)
with guide plate
(The guide plate is not equipped with core bits
with outer diameter of 25 mm and 29 mm.)
Core bit shank
(SDS-plus shank)
25 mm
29 mm
32 mm
35 mm
38 mm
45 mm
50 mm
English
Core bit shank
Core bit shank (A)
Core bit shank (B)
6