Emptying And Servicing - Gloria Profiline 405 T Instrucciones De Uso

2. Once the axle noses are in-
serted, the axle must be rotated
through 90°.
3. Now push the axle through to the
stop on the opposite side.
4. Rotate the axle again through
90°.
5. Now push the axle so far that the
noses on the left and right sides
sit in the notches of the case
part.
Mounting the wheels
25
Fig.
● Push the wheels onto the axle on the
left and right sides. Place a snap-on
fastener on the axle end and push it
onto the axle using a plastic ham-
mer. The wheels must be able to
turn freely.
Note! Snap-on fasteners can only be
removed by destroying them.
Mounting the handle
26
Fig.
● Attach the upper curved rod and
screw together with the straight rod
piece to form a complete handle.
24
27
Fig.
● 1. Position the handle on the pin of
the case part.
Attention! The handle must
point backwards as illustrated.
2. Now push the handle down to
the stop on the pin, the detents
must engage in both holes.
Position and mount the spraying
unit
28
Fig.
● 1. Position the spraying unit as il-
lustrated.
2. Screw spraying unit to handle.
* Available as an accessory or in-
cluded in the scope of delivery in
units 410 TRK and 510 TRK.
Emptying and
Servicing
● Operate the pressure relief valve
(red button) until the unit is no longer
under pressure.