Mosquito Net - Inglesina mhome lodge Manual De Instrucciones

HOW TO FOLD THE TRAVEL COT
fig. 8
EN
fig. 9
fig. 10
fig. 11
fig. 12
HOW TO SET UP THE BASSINET
fig. 13
fig. 14
fig. 15
fig. 16

MOSQUITO NET

fig. 17
26
Remove the mattress (B) from the base.
Grasp the lever (G) in the middle of the base and rotate it clockwise until you
reach the unlocking position.
With the lever still rotated (G) pull up the base of the travel cot for about 20 cm
Push the putton (J) in the middle of each side and press down so that all 4 rails
fold.
Pull up the centre and gather the unit together.
Wrap the mattress (B) around the travel cot with the soft part inside and close
the velcro straps.
First of all correctly open the travel cot. Then attach the support for the bassinet
(C) to the rails using the plastic hooks (H).
Snap the support to all 4 edges (K).
Insert the 4 tubes (D) in the housings (L) at the bottom of the support and insert
them in one another to fully open the bassinet.
Place the mattress (B) on the base of the bassinet.
Put the mosquito net (E) over the travel cot and attach it by passing the hooks
(M) in the buttonholes (N) on the angles.