Disposal - Hilti VC 20-U-Y Manual De Instrucciones

Fault
The battery doesn't en-
gage with an audible click.
The appliance or battery
get very hot.
Doesn't switch over to a
fully-charged battery.
The appliance switches
itself off when a battery is
removed even though a
second battery is already
fitted.

10 Disposal

CAUTION
Improper disposal of the equipment may have serious consequences: The burning of plastic
components generates toxic fumes which may present a health hazard. Batteries may explode
if damaged or exposed to very high temperatures, causing poisoning, burns, acid burns or
environmental pollution. Careless disposal may permit unauthorized and improper use of the
equipment. This may result in serious personal injury, injury to third parties and pollution of the
environment.
CAUTION
Dispose of defective batteries without delay. Keep them out of reach of children. Do not attempt
to open or dismantle batteries and do not dispose of them by incineration.
CAUTION
Dispose of the batteries in accordance with national regulations or return them to Hilti.
Most of the materials from which Hilti power tools or appliances are manufactured can be recycled.
The materials must be correctly separated before they can be recycled. In many countries, Hilti
has already made arrangements for taking back your old power tools or appliances for recycling.
Ask Hilti customer service or your Hilti representative for further information.
For EC countries only
Do not dispose of electrical appliances together with household waste.
In observance of the European Directive on waste electrical and electronic equipment
and its implementation in accordance with national law, electrical appliances and
batteries that have reached the end of their life must be collected separately and
returned to an environmentally compatible recycling facility.
Possible cause
The retaining lugs on the bat-
tery are dirty.
Electrical fault.
No contact.
The battery was not detected.
The battery you removed was
"active", i.e. it was powering
the system.
Remedy
Clean the retaining lugs and
check that the battery engages
securely. Contact Hilti Service
if the problem persists.
Switch the tool off immedi-
ately, remove the battery and
contact Hilti Service.
Reinsert the battery.
Remove the battery from the
appliance and contact Hilti.
Switch the appliance off and
then on again.
en
47