After Finishing Work - Hilti VC 20-U-Y Manual De Instrucciones

2. Check that the level monitoring electrodes
(two metal discs on the underside of the va-
cuum cleaner top section) are clean. If ne-
cessary, use a brush to clean these parts.
7.7.2 When picking up liquids
If possible, use a separate filter element for wet
applications.
NOTE
If possible, use a Hilti PTFE filter element.
If foaming occurs, switch the appliance off
immediately and empty the container.
The appliance switches itself off automatically
when the liquid in the container reaches the
maximum level.
7.7.3 After picking up liquids
1. Open the two catches.
2. Lift the vacuum cleaner top section away
from the waste material container.
3. Empty the container and use a water hose
to clean it. Use a brush to clean the elec-
trodes.

7.8 After finishing work

1. Switch off the power tool.
2. Turn the control switch to the "OFF" posi-
tion.
3. Disconnect the supply cord plug from the
power outlet.
4. Coil the supply cord around the supply
cord storage point.
5. Coil the suction hose around the appliance
and secure the end of the hose in the hose
holder provided.
6. Store the appliance in a secure, dry place
where it is inaccessible to unauthorized
users.
7.10 Using the appliance as a charging station
Overview of the charging station status indicator
7.9 Emptying the waste material container
CAUTION
Remove all items attached to the adapter
plate on the vacuum cleaner top section
(e.g. Hilti toolboxes) before emptying the
container holding the material picked up.
7.9.1 Emptying dry dust from the waste
material container
7.9.1.1 Before emptying the waste
material container, proceed as
follows:
1. Disconnect the supply cord plug from the
power outlet.
2. Lift the vacuum cleaner top section away
from the waste material container and
place it on a level surface.
7.9.1.2 After emptying the waste material
container, proceed as follows:
CAUTION
When fitting the top section of the vacuum
cleaner, take care to avoid pinching your
fingers or damaging the supply cord.
Fit the vacuum cleaner top section onto the
waste material container and close the two
catches.
7.9.2 Emptying the waste material
container when no dust bag is fitted
(collecting liquids)
NOTE
The material collected must be disposed of in
accordance with the applicable regulations.
1. Hold the container by the grip areas
provided and tip it over to empty out its
contents.
2. Clean the edge of the waste material con-
tainer with a damp cloth.
en
41