Starting Operation - stayer BHL112K Manual De Instrucciones

Operation

Starting Operation

Inserting the Battery
f Use only original Stayer lithium ion batter-
ies with the voltage listed on the nameplate
of your power tool. Using other batteries can
lead to injuries and pose a fire hazard.
Set the rotational direction switch 7 to the cen-
tre position in order to avoid unintentional start-
ing. Insert the charged battery 5 into the handle
so that it can be felt to engage and faces flush
against the handle.
Reversing the Rotational Direction
The rotational direction switch 7 is used to re-
verse the rotational direction of the machine.
However, this is not possible with the On/Off
switch 8 actuated.
Right Rotation: For drilling and driving in
screws, push the rotati onal direction switch 7
left to the stop.
Setting the Torque / Setting the Operating
Mode
The required torque can be preselected in 10
steps with the torque preselection ring 3. With
the correct setting, the insert tool is stopped as
soon as the screw is screwed flush into the ma-
terial or when the set torque is reached.
Select a higher setting when driving out screws,
or set to the symbol "Drilling".
Drilling
Set the preselection ring 3 to the "Drilling with-
out impact" symbol.
The safety clutch is deactivated in the "Drilling"
position.
Impact drilling (PBL183PK)
Set the preselection ring 3 to the "Im-
pact drilling" symbol.
In the "Impact drilling" position, the safety
clutch is deactivated and the maximum power is
always effective.
ENGLISH
14
Gear Selection, Mechanical
f Actuate the gear selector 4 only when the
machine is at a standstill.
Two speed ranges can be preselected with the
gear selector 4.
Gear I:
Low speed range; for sc rewdriving or working
with large drilling diameter.
Gear II:
High speed range; for working with small drilling
diameter.
If the gear selector 4 cannot be fully engaged,
lightly rotate the drive spindle with the drill bit
by twisting the drill chuck.
Switching On and Off
To start the machine, press the On/Off switch
8 and keep it pressed.
The light 6 is lit when the On/Off switch 8 is
slightly or completely pressed in and permits to
light the work area when the lighting conditions
are bad.
To switch off the machine, release the On/Off
switch 8
Adjusting the Speed
(PBL211K-PBL143K-PBL183PK)
The speed of the switched on power tool can be
variably adjusted, depending on how far the
On/Off switch 8 is pressed.
Light pressure on the On/Off switch 8 results
in a low rotational speed. Further pressure on
the switch results in an increase in speed.
Run-on Brake
When the On/Off switch 8 is released, the
chuck brakes to a stop, thus preventing the run-
on of the tool.
When driving in screws, wait until the screw is
screwed in flush with the material and then re-
lease the On/Off switch 8 . By doing so, the
head of the screw does not penetrate into the
material.
14