Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT USE / START CLEANING
According to different cleaning needs, the product has a variety of
cleaning modes to choose from. You can start various cleaning modes
through a host, remote control or app.
Automatic Cleaning
Setting method: In the shutdown state, press the button
for a few
seconds. When the indicator light
of the host is on, it indicates that
the host is powered on. When the button
on the host is pressed for
a short time, or press the automatic cleaning button
on the remote
controller, the host starts automatic cleaning.
If it is dustbin instead of water tank installed in the host, and in standby
mode or other working modes, press the button
on the remote
controller, the host starts automatic cleaning. Press the button
again, the host will switch to powerful suction mode. Press the button
once more, the host will switch to quiet cleaning mode. Pressing
the button
additionally more times will make the host switch
between powerful suction mode and quiet cleaning mode circularly.
If the water tank is installed in the host, and in standby or other working
modes, pressing the button
will always make the host enter into
mopping mode.
MOPPING MODE
Applicable scenario: Used to do wet & dry mopping.
Setting method: Install the water tank to the host and press the start
button
on the host or the button
or
(
) on the remote
controller, the host starts mopping mode.
Publicidad
Tabla de contenido
