M1700Ss Display Wall-Mount Locking Mechanism - 3M MicroTouch M1700SS Guia Del Usuario

3M™ MicroTouch™ Display M1700SS User Guide
Figure 6. Disassembling the Display from Its Base for Arm Mounting

M1700SS Display Wall-Mount Locking Mechanism

To lock the M1700SS Display in place for wall mounting, use the locking mechanism
included in a separate bag with your display. Position the monitor to 90° flat and lock the
front latch in place. As an extra measure, insert the U-shaped metal retention clip into the
holes in the base as indicated in the drawing below. Tighten the screw in place and your
display is ready to hang securely on the wall.
Document #19-268
Step 1 – Unlock front mechanism and
disconnect all cables from the display.
Step 2 -- With the unit laying face down safely
and securely on a nonabrasive surface,
remove the two screws connecting the name
plate and support rods to the display. Lift the
support rods out of the base and set aside.
Step 3 -- Then remove the four screws holding
the hinge in place and gently remove the base.
Rev AN
9