3M™ MicroTouch™ Display M1700SS User Guide
Figure 2. Removing the Base Cover
Make sure the display is in its full upright position.
1.
Push in and lift up on each of the two tabs located on the left and right sides of the
2.
base cover. This action will release the base cover.
Slide the cover back towards you to remove.
3.
Figure 3. Releasing the Cable Connector Cover
Press in tabs
Push in on the cable connector tabs as shown above to release from display back.
4.
Gently pull down to release tabs.
Document #19-268
Tabs
Rev AN
Cable Connector
Cover
Base Cover
7