Connecting The Base To The Pabx; Dialing Modes And Recall; Setting Pauses; Temporarily Switching To Tone Dialing (Dtmf) - Siemens Gigaset C590 Manual De Instrucciones

Connecting the base to the PABX

Connecting the base to
the PABX
The following settings are only necessary if
your PABX requires them; see the PABX user
guide.
•

Dialing modes and recall

The current setting is indicated by
Changing the dialing mode
The following dialing modes can be
selected:
u
Tone dialing (DTMF)
u
Dial pulsing (DP)
Ï
¢ ¢
v
Telephony
s
Select dialing mode and press
Ø
§Select§
(
Setting Flash
Your phone is preset at the factory for oper-
ation on the main connection. For operation
on a PABX, you may have to change this
value. Please refer to the user guide for your
PABX.
Ï
¢ ¢
v
Telephony
s
Select recall and press
Ø
( = set value).
Possible values are:
80 ms, 100 ms, 120 ms, 180 ms,
250 ms, 300 ms, 400 ms, 600 ms,
800 ms.
52
Ø
.
¢
Dialing Mode
= selected).
¢
Flash
§Select§

Setting pauses

Changing the pause after line
seizure
You can change the length of the pause that
is inserted between pressing the talk key
c and sending the number.
v
Open the main menu.
*#Q5# L
Press keys.
~
Enter digit for the pause length
(1 = 1 sec.; 2 = 3 sec.; 3 = 7 sec.)
and press
Change pause after recall key
You can change the length of the pause if
your PABX requires this (refer to the user
guide for your PABX).
v
Open the main menu.
*#Q5# 2
Press keys.
~
Enter a digit for the length of the
pause (1 = 800 ms; 2 = 1600 ms;
3 = 3200 ms) and press
Temporarily switching to
tone dialing (DTMF)
If your PABX still operates with dial pulsing
(DP), but you need tone dialing for a connec-
tion (e.g. to listen to the network mailbox)
you must switch to tone dialing for the call.
Prerequisite: You are conducting a call or
have already dialed an external number.
*
Press the star key.
After the call is ended, dial pulsing is auto-
matically activated again.
§OK§
.
§OK§
.