Setting The Alarm Clock; Using Several Handsets; Registering Handsets - Siemens Gigaset C590 Manual De Instrucciones

Ocultar thumbs Ver también para Gigaset C590:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Setting the alarm clock

Setting the alarm clock
Prerequisite: The date and time have
¢
already been set (
Activating/deactivating the alarm
clock and setting the wake-up time
¢
v
Alarm Clock
¤
Change multiple line input:
Activation:
Select On or Off.
Time:
Enter the wake-up time in 4-digit format.
Use the display key to select AM or PM.
Volume:
Use the right and left arrows on the con-
trol key to set the volume.
Melody:
Select the melody to play as the alarm
signal.
§Save§
Press the display key.
¼
In idle state, the
icon and wake-up time
display.
A wake-up call is signaled on the display and
with the selected melody (
wake-up call sounds for 60 seconds. If a key
is not pressed, the wake-up call repeats
twice at five minute intervals and then
switched off.
During an active call, the wake-up call is only
signaled by a short tone.
Deactivating the wake-up call/
repeating after a pause (snooze
mode)
Prerequisite: A wake-up call is sounding.
§Off§
Press the display key. The wake-
up call is deactivated.
Or:
§Snooze§
Press the display key or any key.
The wake-up call is deactivated
and then repeated after 5 min-
utes. After the second repetition
the wake-up call is deactivated
completely.
42
page 15).
¢
page 2). The

Using several handsets

Registering handsets

You can register up to six handsets to your
base.
A Gigaset C59H handset can be registered
on up to four bases.
Manually registering the
Gigaset C59H on Gigaset C590/
C595
You must manually activate registration of
the handset on both the handset (1) and the
base (2).
When the registration process has com-
pleted successfully, the handset returns to
idle state. The handset's internal number is
shown in the display e.g. INT 1. If not, repeat
the procedure. .
1) On the handset
If the handset is not registered to any base.
§Register§
Press the display key.
If the handset is already registered to a
base:
Ï
¢
¢
v
Registration
¢
Register Handset
A message displays that a search for a base
that is ready for registration is being car-
ried out.
~
If required, enter the system
PIN for the base and press
If the handset is already registered to more
than one base:
s
Select the base, e.g. Base 3
and press
2) On the base
Within 60 seconds press and hold the reg-
istration/paging button on the base
¢
(
page 3) (for approx. 3 seconds).
§OK§
.
§OK§
.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Gigaset c595

Tabla de contenido