Acknowledging Errors - Wilo Helix EXCEL 110 Instrucciones De Instalación Y Funcionamiento

English
E110 immediate immediate
E111 ~5s
immediate Immediate if defect
E112 immediate
E119 immediate immediate
Example of error
page.
30
Immediate if defect
deleted
Immediate if defect
300s
deleted
deleted
Immediate if defect
deleted
no limit Loss of synchronization
The motor currents exceeds
6 the limit of the maximum
converter output current
no limit Motor speed exceeds 120% of
the rated speed
The pump tried to start
no limit without success while it
veers

10.2 Acknowledging errors

CAUTION! Material damage!
Only acknowledge defect when they have been
remedied.
• Only skilled technicians are allowed to remedy the
defect.
• If in doubt, contact the manufacturer.
• In the event of an error, the error page is dis-
played instead of the status page.
To acknowledge, proceed as follows.
• Press the Red Button.
It appears on the display:
• The menu number <6.0.0.0> .
• The defect number and the maximum number
over 24 hours of the concerned defect (example:
1/6).
• The remaining time before auto reset of the de-
fect, in seconds.
• Wait for the auto reset time.
A timer runs within the system. The remaining
time (in seconds) is displayed until the error is
automatically acknowledged.
• When the maximum number of the defect is
reached and the last timer has elapsed, press the
encoder to acknowledge.
The system returns to the status page.
NOTE: When there is a time before considering of
the defect, after signalling (example: 300s), the
defect must always be manually acknowledged.
The auto reset timer is inactive and "- - -" is dis-
played.
The pump restarts automatically
Density and/or viscosity of the con-
veyed fluid exceed pump limits. Check
if the pump is not obstructed by
particles
Regulation to normal motor limits.
Check the tightness of the non-re-
turn valve.
Example of status
page
WILO SE 05/2014
0s
0s
0s
0s