Cleaning The Oven Door; Replacing The Light Bulb - SCHOLTES FP E6.1 S Manual De Instrucciones

• All accessories - with the exception of the sliding racks
GB
- can be washed like everyday crockery, and are even
dishwasher safe.
! Never use steam cleaners or pressure cleaners on the
appliance.

Cleaning the oven door

Clean the glass part of the oven door using a sponge and
a non-abrasive cleaning product, then dry thoroughly with a
soft cloth. Do not use rough abrasive material or sharp metal
scrapers as these could scratch the surface and cause the
glass to crack. For more thorough cleaning purposes, the
oven door may be removed:
Inspecting the seals
Check the door seals around the oven regularly. If the seals
are damaged, please contact your nearest Service Centre
(see Assistance). We recommend that the oven is not used
until the seals have been replaced.

Replacing the light bulb

Oven
compartment
Lamp
Seal (only on a
few models)
Glass door
! Do not use the oven lamp as/for ambient lighting.
32
Open the oven door fully (see
diagram);
2. Lift up and turn the small levers
located on the two hinges
(see diagram);
3. Grip the door on the two external
sides and close it approximately
half way. Pull the door towards you,
lifting it out of its slot (see diagram).
To replace the door, reverse this
sequence.
To replace the oven light bulb:
1. Remove the glass cover
using a screwdriver.
2. Unscrew the light bulb and
replace it with a similar one:
Wattage 15 W, cap E 14.
Replace the glass cover,
making sure the seal is
positioned correctly (see
diagram).
Automatic cleaning using the PYROLYSIS
cycle
During the PYROLYSIS cycle, the internal temperature
of the oven reaches 500°C. When the pyrolytic cycle is
activated, food and grime residues are burnt away. Dirt is
literally incinerated.
Keep children away from the appliance during the automatic
cleaning cycle as surfaces may become very hot. Particles
may ignite inside the oven as a result of the combustion
process. There is no cause for concern: this process is both
normal and hazard-free.
Before initiating the PYROLYSIS cycle:
• remove large or coarse food residues from the inside of
the oven using a damp sponge. Do not use detergents;
• remove all accessories;
• do not place tea towels or pot holders over the oven
handle;
• turn the SELECTOR knob to the "0" position.
! If the oven is too hot, the pyrolytic cycle may not start.
Wait for the oven to cool down.
! The cycle may only be started once the oven door has
been closed.
To activate the PYROLISIS cleaning cycle, press and hold
the button for approximately 4 seconds. The SET TIME
KNOB may be used to select the desired cleaning level; there
are three default time settings which cannot be modified.
1. Economy (ECO): turn the knob towards " ". Duration 1 hour.
2. Normal (NOR): initial level. Duration 1 hour and 30 minutes.
3. Intensive (INT): turn the knob towards " ". Duration 2 hours.
4. Press the button to confirm.
An end time for the PYROLISYS cycle (as for a normal
cooking cycle) may be programmed (see Programming the
automatic cleaning end time).
Safety devices
• the icon on the display, when lit, indicates that
the oven door was automatically locked as soon as the
temperature reached a high value;
• the icon indicates that the cleaning cycle may
be cancelled at any time by pressing the
• if a malfunction occurs, the heating elements will be
switched off;
• once the oven door has been locked, you cannot change
the duration and cycle end time settings.
button;