WEG CFW500 Guía De Instalación, Configuración Y Operación página 7

The RS232 plug-in module presents the following
features:
Parameterization, command and monitoring of
„
the inverter by SuperDrive G2 e WLP application
software (available in CFW500 CD-ROM).
CFW500 firmware programming/atualization by FDT
„
application software (available in CFW500 CD-ROM).
ATTENTION!
With switches S2.1=ON and S2.2=ON the
inverter stays in the firmware programing
state. This operation must only be executed
under WEG's orientation. Improper use of
this application may damage the equipment.
This module has a connector
use of the CFW500-MMF Flash Memory Module , which
allows data transfer between inverters. For further details
on this accessory, refer to the installation and operation
guide of the CFW500-MMF.
NOTE!
When connecting to the PC, the associated
„
serial port is automatically determined by
the operating system some seconds after
the connection. The user can easily identify
or change the associated COM port in:
Control Panel → System → Hardware →
Device Manager → COM & LPT Ports.
For further details, refer to the installation
„
manual available in the CD-ROM.
RS232 Communication Plug-in Module
(figure A.2) to enable the
CFW500 | 9