Laundry Detergents And Additives; Adding The Correct Amount Of Detergent; Filling Laundry Detergent And/Or Additives - Bosch Vision 300 Serie Manual De Usuario

Laundry
Detergents and
Additives
Adding the correct
amount of detergent
TO AVOID RISK OF POISONING!
Keep detergents and additives out
of the reach of children.
Measure out the detergent (powder or
liquid) according to:
The water hardness. This
information can be obtained from
your local water authority. Soft
water requires less detergent.
The amount of laundry.
The degree of soiling. Information
on soiling can be found on Page
19.
The specifications of the detergent
manufacturer. Measuring the
correct amount of detergent
reduces the strain on the
environment and ensures optimum
washing results.
Too little detergent:
The laundry is not cleaned properly and
will eventually become gray and stiff.
Grayish brown spots may appear on
the laundry. The heater may calcify.
Too much detergent:
Excessive suds reduce wash agitation
producing poor washing and rinsing
results and may prevent proper
spinning.
Filling laundry detergent
and/or additives
Open the detergent dispenser
drawer.
rs
Add the liquid detergent and/or
additive. First check to be sure the
liquid insert is present in the
detergent compartment (1). If
using a powder detergent, see the
note below on removing the liquid
detergent insert.
Do not overfill the compartment to
avoid early dispensing.
DO NOT operate the washer
without the detergent drawer in
place and fully closed!
If using a powder detergent, first
remove the liquid detergent insert
from compartment 1.
Store the liquid detergent insert for
later use.
We recommend HE detergents
because they are designed to
achieve optimum performance
with your front-loading washer.
Not using HE detergent could
cause problems such as
oversudsing, extended cycle
periods, or a decrease in wash
performance.
Look for the HE logo (pictured
below) on the front of your
detergent product.
Detergent Dispenser
Compartments
[] Detergent Compartment
Use to add detergent to the wash
load.
Liquid detergent should only be
used with the liquid detergent
insert in place.
Add only the correct measured
amount of detergent to avoid
oversudsing.
DO NOT overfill for liquid
detergent, stop at the fill level
marked as "max" on the siphon
cap (see illustration above).
At the beginning of the wash cycle,
the detergent is flushed from the
dispenser into the wash.
If using powder detergent, first
remove the liquid detergent insert
[] Fabric Softener Compartment
Add the recommended amount of
fabric softener.
DO NOT overfill stop at the fill
level marked as "max" on the
siphon cap (see illustration above).
Overfilling can cause the softener
to be dispensed early
DO NOT pour fabric softener
direcly into the wash load.
The fabric softener will
automatically be dispensed during
the last rinse cycle.
Do not use fabric softener with
outdoor fabrics (ie: rubberized or
waterproof materials).
2O