Acoustic Signal; Special Features (Auto Load Adjust, Avstmanti-Vibration System) - Bosch Vision 300 Serie Manual De Usuario

Modifiers
Spin Selection
Preset cycle setting of max. spin speed
can be changed.
Press this button until the desired
setting lights up.
D'No final spin ("---")The water is
drained from the machine after the
final rinse. Recommended for
delicate laundry. Use this setting to
avoid creasing if the clothing
cannot be taken out of the
washing machine immediately
upon completion of the cycle.
Delay Start
Before starting a program you can
modify by when the cycle should be
started.
1 press = +1 hour
Press Delay Start button. The display
shows the start time 0:00.
The time can be delayed up to a
maximum of 19 hours (with 1 hour
increments) by pressing the Delay
Start button repeatedly.
The Start time begins running
immediately after pushing the
Start/Pause button. This is indicated
by the points between the digits
flashing.
D Changes to the Start time are
possible at any time, press the
Delay Start button until the new
time appears.
D If the program is changed or if the
program is interrupted, the
preselected Start time is also
interrupted. The Ready in time of
the program is displayed. The
Start time must be reselected.
Acoustic Signal
An acoustic signal indicates program
statuses (e.g. start/end of program and
operating faults.)
To activate the signal:
Select a program.
Press and hold any two Option
Buttons (e.g. Stain Removal and
Allergy Rinse) until a long signal is
emitted.
To deactivate the signal:
Select a program.
Press two of the Option Buttons
and hold until a short signal is
emitted.
D Do not activate/deactivate the
acoustic signal during a cycle.
"Start/Pause" button light
The Start/Pause button light conveys
the following information:
Indicator light flashing red:
Program can be started.
Adding laundry is possible.
Indicator light is lit red. Program is
running.
Adding laundry is not possible
because the door is locked for
safety reasons.
Laundry may be added after pressing
the Start/Pause button.
Special features
Auto Load adjust
"Auto Load adjust" adjusts the water
and energy consumption for each cycle
and determines the amount of laundry.
This process is built into your machine
and occurs automatically.
The result is a reduction in water and
energy consumption when washing
small loads.
AVS
TM
Anti-Vibration System
Unbalanced load detection
The AVS TM automatic unbalanced load
detection system determines whether
or Plotthe load is correctly balanced for
spinning. If the load is not evenly
distributed, the spin will be restarted. If
after a pre determined Plumber of
attempts the load cannot be balanced
the spin will be aborted and the cycle
resumed.
Displayed Time
When a cycle has been selected, the
expected cycle time is displayed.
The following will affect the displayed
time:
Load size
Repeated spin attempts to evenly
distribute load
Additional rinse cycles if excessive
foam occurs
Low water pressure
Selection of additional options,
e.g. "Allergy Rinse"
Due to these and other characteristics
of the controls, the actual cycle time will
vary.
You may notice that these effects
(more or less time) change the
displayed time when they occur in
the cycle. If no options are
selected and these effects do not
occur, the time indicated will be
the time that the cycle will finish.
24