Zodiac RV 5480 iQ Manual De Instalación Y De Uso página 41

4.3.5 Remove from water mode "Lift System"
The Lift System functi on was designed to facilitate removing the cleaner from the water. It may be acti vated at any
moment, during or at the end of a cleaning cycle.
• Only acti vate the Lift System functi on if the cleaner in in view.
• In the app's home screen, select Lift System.
• To guide the cleaner to the desired pool wall, use the left or right arrow.
• When the cleaner is against the pool wall, press Lift System. The cleaner will start to move to the pool wall and raise
itself to the water line.
• To stop an acti on in progress, press Lift System again.
• Using the handle, lift the cleaner from the water. At that moment, the cleaner will expel a powerful jet of water. It will
then be lighter to lift from the water.
• Remove the cleaner completely from the water.
• Press (X) to return to the home screen.
• Don't pull on the fl oati ng cable to raise the cleaner and remove it from the pool, use the
cleaner's handle.
4.3.6 Programming or cancelling cleaning cycles
Cleaning cycles may be programmed to repeat.
• You are strongly recommended to remove and clean the fi lter aft er every cleaning cycle.
• From the app's home screen, select Next Cleaning Cycle or go into Setti ngs and select Edit Schedule.
• Select the day of the week. Only one program is possible per day.
• Select a start ti me for the cleaning cycle.
• The ti me display can be customised from the Setti ngs menu. Simply acti vate or deacti vate the 24h ti me
format; if deacti vated, the ti me will be displayed in a.m./p.m. format.
• Press Save to save the programming or Cancel to erase it.
Repeat these steps to program other cleaning cycles.
• The cleaning cycle durati on may vary depending on the cleaning parameters selected in cleaning mode,
see "4.3.3 Setti ng up a cleaning mode".
• To delete a programmed cycle, select the day programmed and press Delete Schedule.
• Press (X) to cancel and return to the home screen.
The next cleaning cycle programmed is displayed in the home screen.
• The cleaning cycle that will start during the programme will be the last cleaning cycle selected, see "4.3.3
Setti ng up a cleaning mode".
EN
15