Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
6.2. WHASING SPRAY JET SYSTEM
19. Rejilla para depósitos de pistolas
20. Boquilla pulverizadora
21. Pulverizador de limpieza
22. Boquilla de soplado
23. Soporte para tapas de depósitos
24. Tuerca fijación de la araña
25. Clip de pistolas en Nylon
6.3. MAIN MACHINE CONTROLS
26. Automatic washing timer
27. Valve ON/OFF main machine
28. Valve ON/OFF of the atomized
29. Valve ON/OFF brush
30. Rinse button
31. Exchange valve dirt-clean
32. Labels for warnings
INCORRECT INSTALLATION OF THE MACHINE
MAY CAUSE DAMAGE TO PEOPLE, ANIMALS OR
OBJECTS. THE MANUFACTURER CANNOT BE
CONSIDERED RESPONSIBLE FOR THESE DAMA-
GES.
7.1 TRANSPORT AND DISCHARGE
The equipment COMPACT 235 is delivered
packaged. It must be transported and stored
according to the indications on the packaging.
Due to the low weight of the equipment COM-
PACT 235 can be moved by two people without
using other means.
7.2 ARRANGEMENT OF THE LIGHTING SYSTEM
The Client must make sure that there is suitable
lighting for the surroundings and that the lighting
conforms to the regulations in force. In particular,
the Client must arrange the positioning of lighting
that illuminates all the working area.
7.3 ARRANGEMENT OF THE PNEUMATIC SYSTEM
The Client must arrange a line of filtered com-
pressed air supplied by a compressor that is
suitable for the consumption required. Do not use
20
25
26
31
7. INSTALATION
compressed air that contains chemical products,
synthetic oil with organic solvents, salts or corro-
sive gases as they can cause damage or malfunc-
tioning. The line of compressed air must arrive up
to the supply points of the machine. If the com-
pressed air contains a large amount of moisture,
it may cause malfunctioning in the valves and in
the pneumatic components. Install a moisture
separator downstream from the compressor to
avoid this.
7.4. CLASSIFICATION ACCORDING TO THE ATEX
DIRECTIVE
The machine conforms to the essential requisites
of the EU Directive 94/9/EC, better known as
ATEX ("Explosive atmospheres"). It is classified as
group II category 3 letter G system. The assess-
ment procedures of conformity, carried out by an
internal factory check, allow the installation of
the machine in surroundings where there may be
potentially explosive atmospheres due to the
presence of gas, fumes or mist.
Preparation for extraction of gases
For the compliance ATEX, the machine is equi-
pped with a system of forced evacuation of the
fumes generated during the operation.
- 16 -
21
19
22
24
23
27
28
32
30
29
Publicidad
Tabla de contenido
