Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
The smoke evacuation takes place through a
chimney on the upper end of the machine and is
powered by a forced suction (venture effect) that
is automatically activated depending on the
mode of operation of the machine.
This chimney must then be connected to the gene-
ral workshop extraction or brought outside the
workshop.
In this second case, the chimney connected to the
machine must cover at least a portion in the verti-
cal of 1 meter before being led outside.
For an easy installation, the chimney is generally
an aluminum tube, flexible and extensible.
The fumes of solvent dispersed in that way do not
need further treatment.
II 3 GD
7.5. POSITIONING
The COMPACT 235 must be positioned in a
well-aired place.
The area must be equipped with all means provi-
ded for by the Italian Legislative 626/94,
relating to Italian Legislation with reference to the
health and safety of the workers in the working
environment.
Position the machine on the floor and make sure
that there is sufficient space around the machine
to carry out normal maintenance operations or
inspections.
8.1. INITIAL WASHING
1. Dismantle the gun and empty the canister into
a suitable recipient. Raise the lid of the machine.
2. Raise the lid of the tub Press the trigger of the
spray gun and use the nylon clip (No25) to block
the trigger of the spray gun.
3. Insert the blower nozzle into the air inlet of the
spray gun as shown in the diagram.
4. Place the spray gun
and
relative
compo-
nents on the washing
spray jet system inside
the washing tub taking
care to insert the spray
gun
into
the
spray
nozzle (Noº21).
7.6. PUTTING INTO USE
The operations for connecting the machine to the
pneumatic mains supply and positioning the
pipes in the various drums are described below.
1. Connect the earthing cable (No13) provided
with the machine and marked yellow/Green on
the cable lug to a screw on the machine Hood
(No14), on the side of the free terminal to the
earth contact of electric system.
2. Make sure that the ON/OFF switches (No27)
of the machine are in the off position (horizontal).
3. Connect the machine air connection (No15) to
the line of compressed air (max. 10 bar).
4. Remove the lower door of the machine.
5. Put two drums half-filled with clean solvent on
the bottom at the base unit. One of them must be
placed under the drain of the washing tank.
Immerse the two suction pipes (No6 and No7)
equipped with their filters in the drum placed
under the drain, which will always contain recir-
culation solvent.
6. Insert the two suction pipes (No8 and No9) for
clean solvent into the second drum which will
always contain clean solvent
7. Replace the lower front door of the machine
read this manual carefully to ensure the best
performance from your machine.
Make sure that users read, understand and
comply with all the precautions and warnings
contained herein.
8. WASHING INSTRUCTIONS
It is advisable to use the automatic wash cycle
with full loads only, otherwise there is a risk that
the nozzles not occupied by the canister or spray
gun
solvent
onto the lid of the
tub, causing leaka-
ge of solvent.
- 17 -
may
spray
directly
Publicidad
Tabla de contenido
